Pour TheoryUnderstand the Science. Master the Craft.

Wicks & Wick Selection

Systematic Wick Testing Protocol

Structured, repeatable burn testing separates reliable craft studios from guesswork—documenting flame height, melt pool, soot, and container thermal safety from top to bottom.

8 minute read · Updated 2026-11-11

Structured, repeatable burn testing separates reliable craft studios from guesswork—documenting flame height, melt pool, soot, and container thermal safety from top to bottom.

01. Running a Three-Size Bracket Test

Pour three identical test candles differing ONLY by wick size (e.g., Size N−1, Size N, Size N+1). Label each vessel base clearly with batch ID, fragrance %, pour temp, and wick SKU. Cure fully before lighting.

Place all three vessels at least 15–20 cm (6–8 in) apart on a non-combustible surface in a draft-free room. Trim wicks to 6 mm (1/4 in), burn for 4-hour sessions, allow full cooling (at least 4–5 hours) between sessions, and log measurements until the candle reaches its sustainer collar.

Common mistakes

  • Stopping burn tests halfway down the jar before testing the hotter, oxygen-restricted bottom third.
  • Testing candles side by side too closely (within 5 cm), where radiant heat from adjacent flames skews results.

Safety considerations

  • Also perform supervised "power burn" stress checks (extended single burns) on final candidate formulations to observe worst-case consumer misuse behavior safely.

Frequently asked questions

How many total burn sessions does a full wick test require?

Test through the complete life of the candle—typically 6 to 12+ four-hour burn cycles depending on net wax mass.

This page is part of the Pour Theory educational reference library. Verify all production settings against the current documentation for your specific wax, fragrance, wick, and vessel.