Pour TheoryUnderstand the Science. Master the Craft.

Diagnostic guide

Uneven Burning

Uneven burning happens when a candle consumes wax noticeably faster on one side than the other, leaving a tall unmelted ridge on the opposite wall.

Visual appearance

An off-center melt pool, leaning flame, or one side of a jar completely clean while the opposite glass wall retains thick unmelted wax.

Common causes

  • Off-center wick placement at the base or crooked wick pulling to one side during cooling.
  • Directional air draft from a window, fan, or doorway pushing flame heat toward one side.
  • Natural curl direction of certain flat-braid wicks if not centered carefully or rotated in multi-wick layouts.
  • Unevenly level burn surface tilting the molten pool.

Diagnosis steps

  • Measure wick tab placement from the inner vessel wall in four cardinal directions using calipers or a ruler.
  • Rotate the burning candle 180 degrees during testing; if the fast-melting side switches to match the room orientation, an air draft is responsible.

Corrective actions

  • Use precision wick-centering tools both at sticker adhesion and at the jar rim until wax solidifies fully.
  • Trim wicks straight prior to testing and position candles on level, draft-free testing benches.
  • For multi-wick jars, verify symmetrical spacing so thermal zones overlap evenly without pushing flames toward one glass wall.

What to test next

  • Conduct a rotated burn test in a shielded test bay using a verified center-stamped wick holder.

Prevention

  • Standardize wick-centering fixtures for every vessel diameter in production.

Safety considerations

  • A flame burning too close to one glass wall creates dangerous localized thermal stress that can crack glass vessels; always verify wick centering within tight production tolerances.