Pour TheoryUnderstand the Science. Master the Craft.

Diagnostic guide

Sinkholes & Internal Cavities

Sinkholes occur when the outer crust and surface of a candle solidify first while the hotter liquid core shrinks inward as it cools, pulling the center downward or trapping hollow cavities around the wick.

Visual appearance

Funnel-shaped depressions around the wick, sunken tops, or hidden hollow pockets that appear only once the candle begins burning.

Common causes

  • Natural volumetric contraction of waxes (especially paraffin, palm, and rigid pillar blends) transitioning from liquid to solid.
  • Pouring too hot in high-shrinkage waxes, increasing total volume contraction inside the vessel.
  • Rapid exterior cooling causing the top skin to seal before interior shrinkage completes.
  • Air trapped while stirring aggressively prior to pouring.

Diagnosis steps

  • Slice or probe a cooled test candle near the wick to inspect whether hollow pockets formed just below a seemingly flat top.
  • Note whether depressions occur uniformly in the center (contraction) or off-center near bubbles (trapped air).

Corrective actions

  • Slow cooling speed by insulating vessels/molds and pre-warming containers.
  • For pillars and high-shrinkage waxes, poke relief channels beside the wick while partially cooled and perform a planned second pour.
  • For single-pour container blends, adjust pour temperature within the manufacturer TDS window and stir gently without whipping air.
  • Use a gentle heat-gun pass only for minor shallow surface dips—never rely on heavy top-melting to mask deep internal cavities.

What to test next

  • Cut a vertical cross-section through a sacrificial test candle after 24 hours to verify there are zero hidden air voids near the wick.

Prevention

  • Establish standardized pouring temperatures and cooling rack spacing in your batch protocol.

Safety considerations

  • Deep concealed cavities around the wick can cause sudden flame flaring or wick collapse when the melt pool breaks into an air pocket; always inspect cross-sections when developing a new pillar or container blend.