Pour TheoryUnderstand the Science. Master the Craft.

Diagnostic guide

Excessive Flame Height

Excessive flame height occurs when the wick supplies fuel faster than safe equilibrium, producing an elongated, unstable flame that overheats the vessel and emits smoke.

Visual appearance

Tall, flickering flames extending well past 35–40 mm (~1.5+ in), frequently dancing, smoking, and creating excessively deep melt pools.

Common causes

  • Over-wicked candle (wick gauge too large for the vessel diameter and wax viscosity).
  • Failing to trim the wick prior to lighting.
  • Low-flash-point or volatile incompatible fragrance oil vaporizing excessively.
  • Dual or triple wicks placed too close together, merging thermal plumes.

Diagnosis steps

  • Extinguish, trim wick strictly to 6 mm (1/4 in), re-light, and measure steady-state flame height after 1–2 hours.
  • Measure outer container wall temperature using a calibrated infrared thermometer during the 3rd and 4th hours.

Corrective actions

  • Drop down one or two wick sizes immediately and re-test through the entire candle lifecycle.
  • Verify fragrance oil flash point and suitability for candle combustion; lower fragrance percentage if flame flare persists.
  • Increase spacing between multiple wicks or drop down individual wick gauges in multi-wick vessels.

What to test next

  • Perform a full "power burn" test (extending slightly past standard intervals under supervision) while checking glass surface temperature against ASTM F2179 guidelines.

Prevention

  • Prioritize flame safety and container temperature thresholds above aggressive hot-throw optimization.

Safety considerations

  • Excessive flame height is a direct fire and glass-shatter hazard (violating ASTM F2417 flame height limits). Never sell or gift a candle exhibiting torching flames.